文件名称：示波器模拟软件
文件大小：12KB
文件格式：GZ
更新时间：2016-08-07 10:06:24
并口 示波器 PC C
Scope 1.0 for Linux ELF ======================= This is an oscilloscope program written in c using the XForms library. It uses the PC's parallel port for data input. The way it's done is as follows: first data bit 1 is set to 1 then to 0 to enable the a-to-d converter ( ADC0801 ), then we read 4 bits of data from the multiplexer ( 74LS157 ) placed after the a-to-d, then a 1 is sent to the second data bit and the other four bits of data are read. The circuit is setup as follows: ---------------------------------------------------------<---- Data bit 1 | | ---------------- -------------- | | D0|-------->----------| Select|----<---- Data bit 2 |---|Enable D1|-------->----------| | From | D2|-------->----------| O0|---->---- Status bit 4 Circuit->--|Ain D3|-------->----------| O1|---->---- Status bit 5 | D4|-------->----------| O2|---->---- Status bit 6 From | D5|-------->----------| O3|---->---- Status bit 7 555 timer->|CLK D6|-------->----------| | | D7|-------->----------| | ---------------- -------------- ADC0801 74LS157 The parallel port used as default is 0x378 but it can be changed within the program. Other options such as number of points per screen update and a few more can also be set from the options dialog. The 555 timer is an easy chip to configure. Set it to between 70 and 100kHz. You will need the data-sheets for these 3 chips; these can be found at www.national.com in pdf format. One thing I haven't been able to figure out yet is the frequency response of this setup. If anyone can help me with that it would be greatly appreciated. Amplitude sensitivity is approximately 0.04 volts per bit change. Also, because this program accesses the hardware directly, you will need to run it as root ( pretty obvious ). If you have any questions regarding the circuit setup or operation just let me know through e-mail and I'll write back with the solution.
【文件预览】：
scope-0.1
----scope.c(9KB)
----README(248B)
----Makefile(466B)
----scope.1(5KB)
----COPYING(18KB)