【文件属性】：
文件名称：配置路由器的密码-CCNA中文版PPT
文件大小：10.75MB
文件格式：PPT
更新时间：2021-04-25 17:52:44
CCNA
配置路由器的密码
*
Layer 2 of 2
Emphasize: The router has one enable password. Remember that this is your only protection. Whoever owns this password can do anything with the router, so be careful about communicating this password to others. To provide an additional layer of security, particularly for passwords that cross the network or are stored on a TFTP server, you can use either the enable password or enable secret commands. Both commands accomplish the same thing; that is, they allow you to establish an encrypted password that users must enter to access enable mode (the default), or any privilege level you specify. Cisco recommends that you use the enable secret command because it uses an improved encryption algorithm. Use the enable password command only if you boot an older image of the Cisco IOS software, or if you boot older boot ROMs that do not recognize the enable secret command. If you configure the enable secret password, it is used instead of the enable password, not in addition to it.
Cisco supports password encryption. Turn on password encryption using the service password-encryption command. Then enter the desired passwords for encryption. Immediately, on the next line, enter the no service password-encryption command. Only those passwords that are set between the two commands will be encrypted. If you enter service password-encryption and then press Ctrl-Z to exit, all passwords will be encrypted.
Note: Password recovery is not covered in the course materials. Refer the students to the IMCR class.