CentOS 7 配置静态IP后不生效 & Job for network.service failed

时间：2021-01-16 06:28:15

参考：http://tieba.baidu.com/p/3233996339#57290767555l

在CentOS中配置静态IP后不生效。

解决办法：将/etc/sysconfig/network-scripts/ifcfg-eth0文件中的DEVICE=eth0注释掉

解决过程：

一开始，配置文件/etc/sysconfig/network-scripts/ifcfg-eth0内容如下：

TYPE=Ethernet

PROXY_METHOD=none

BROWSER_ONLY=no

BOOTPROTO=static

DEFROUTE=yes

NM_CONTROLLED="no"

IPV4_FAILURE_FATAL=no

IPV6INIT=yes

IPV6_AUTOCONF=yes

IPV6_DEFROUTE=yes

IPV6_FAILURE_FATAL=no

IPV6_ADDR_GEN_MODE=stable-privacy

NAME=eth0

DEVICE=eth0

ONBOOT=yes

IPADDR=192.168.30.140

NETMASK=255.255.255.0

GETWAY=192.168.1.1

DNS1=114.114.114.114

试了网上其他人说的方法，比如

方法1. 禁用NetworkManager

　　systemctl stop NetworkManager

　　systemctl disable NetworkManager

方法2. 在/etc/sysconfig/network-scripts/ifcfg-eth0文件中设置

　　NM_CONTROLLED="no"

还试了其他一些方法，都没用。而且发现使用 systemctl restart network报错：

[root@node05 ~]# systemctl restart network
Job for network.service failed because the control process exited with error code. See "systemctl status network.service" and "journalctl -xe" for details.
[root@node05 ~]# systemctl status network
● network.service - LSB: Bring up/down networking
Loaded: loaded (/etc/rc.d/init.d/network; bad; vendor preset: disabled)
Active: failed (Result: exit-code) since Fri 2019-04-26 09:03:05 EDT; 8s ago
Docs: man:systemd-sysv-generator(8)
Process: 9950 ExecStart=/etc/rc.d/init.d/network start (code=exited, status=1/FAILURE)

Apr 26 09:03:05 node05 network[9950]: RTNETLINK answers: File exists
Apr 26 09:03:05 node05 network[9950]: RTNETLINK answers: File exists
Apr 26 09:03:05 node05 network[9950]: RTNETLINK answers: File exists
Apr 26 09:03:05 node05 network[9950]: RTNETLINK answers: File exists
Apr 26 09:03:05 node05 network[9950]: RTNETLINK answers: File exists
Apr 26 09:03:05 node05 network[9950]: RTNETLINK answers: File exists
Apr 26 09:03:05 node05 systemd[1]: network.service: control process exited, code=exited status=1
Apr 26 09:03:05 node05 systemd[1]: Failed to start LSB: Bring up/down networking.
Apr 26 09:03:05 node05 systemd[1]: Unit network.service entered failed state.
Apr 26 09:03:05 node05 systemd[1]: network.service failed.

最终在贴吧里看到将DEVICE=eth0注释掉的方法，试了一下，静态IP生效了，但是systemctl restart network仍然报错。原因未知。。。。反正静态IP配置好了，但是浪费了好多时间。。。

2019/4/27  把DEVICE注释掉后不能联网了，why....

2019/5/17  将路由地址，默认网关，DNS配置好可解决大部分配置静态地址后不能上网的问题。

eg.

[root@node04 test]# ifconfig

ens33: flags=<UP,BROADCAST,RUNNING,MULTICAST>  mtu

        inet 192.168.30.139  netmask 255.255.255.0  broadcast 192.168.30.255

        inet6 fe80:::f55c:b51d:9cc7  prefixlen   scopeid 0x20<link>

        ether :0c::f3:da:5a  txqueuelen   (Ethernet)

        RX packets   bytes  (20.0 MiB)

        RX errors   dropped   overruns   frame

        TX packets   bytes  (23.3 MiB)

        TX errors   dropped  overruns   carrier   collisions 

lo: flags=<UP,LOOPBACK,RUNNING>  mtu

        inet 127.0.0.1  netmask 255.0.0.0

        inet6 ::  prefixlen   scopeid 0x10<host>

        loop  txqueuelen   (Local Loopback)

        RX packets   bytes  (8.7 MiB)

        RX errors   dropped   overruns   frame

        TX packets   bytes  (8.7 MiB)

        TX errors   dropped  overruns   carrier   collisions 
[root@node04 test]# route

Kernel IP routing table

Destination     Gateway         Genmask         Flags Metric Ref    Use Iface

default         gateway         0.0.0.0         UG                 ens33

192.168.30.0    0.0.0.0         255.255.255.0   U                  ens33
[root@node04 network-scripts]# pwd

/etc/sysconfig/network-scripts

[root@node04 network-scripts]# cat ifcfg-eth0

TYPE=Ethernet

PROXY_METHOD=none

BROWSER_ONLY=no

BOOTPROTO=static

DEFROUTE=yes

IPV4_FAILURE_FATAL=no

IPV6INIT=yes

IPV6_AUTOCONF=yes

IPV6_DEFROUTE=yes

IPV6_FAILURE_FATAL=no

IPV6_ADDR_GEN_MODE=stable-privacy

NAME=eth0

DEVICE=eth0

ONBOOT=yes

IPADDR=192.168.30.138

NETMASK=255.255.255.0

GETWAY=192.168.1.1

DNS1=114.114.114.114

相关文章