centos6.x 配置bond
摘要: centos6.x下使用双网卡配置bond0, centos6 bond配置不需要在/etc/modprobe 中定义bond 直接在网卡中定义BONDING_OPTS 即可,例如bond0: BONDING_OPTS="mode=0 miimon=100"
物理网卡eth0 eth1绑定为bond0
1 物理网卡配置
ifcfg-eth0
DEVICE=eth0
ONBOOT=yes
BOOTPROTO=none
MASTER=bond0
SLAVE=yes
ifcfg-eth1
DEVICE=eth1
ONBOOT=yes
BOOTPROTO=none
MASTER=bond0
SLAVE=yes
2 bond0网卡配置
ifcfg-bond0
DEVICE=bond0
ONBOOT=yes
BOOTPROTO=none
IPADDR=xx.xx.xx.xx
NETMASK=xx.xx.xx.xx
GATEWAY=xx.xx.xx.xx
DNS1=xx.xx.xx.xx
BONDING_OPTS="mode=0 miimon=100"
重启网卡
service network restart
3 查看bond0网卡状态
[root@localhost network-scripts]# cat /proc/net/bonding/bond0
EthernetChannelBondingDriver: v3.7.1(April27,2011)
BondingMode: load balancing (round-robin)
MII Status: up
MII PollingInterval(ms):100
UpDelay(ms):0
DownDelay(ms):0
SlaveInterface: eth1
MII Status: up
Speed:1000Mbps
Duplex: full
LinkFailureCount:0
Permanent HW addr:00:0c:29:a1:34:eb
Slave queue ID:0
SlaveInterface: eth2
MII Status: up
Speed:1000Mbps
Duplex: full
LinkFailureCount:0
Permanent HW addr:00:0c:29:a1:34:e1
Slave queue ID:0
Tips: 日志可以使用
tailf /var/log/messages实时查看