——————————————
（一）出现如下错误启动信息
——————————————
U-Boot 1.3.4 (Jun 30 2011 - 09:01:15) for SMDK2416
CPU: S3C2416@400MHz
Fclk = 800MHz, Hclk = 133MHz, Pclk = 66MHz
Board: SMDK2416 Mobile DDR
DRAM: 64 MB
Flash: 1 MB
NAND: 128 MB
*** Warning - bad CRC or NAND, using default environment
In: serial
Out: serial
Err: serial
Hit any key to stop autoboot: 0
SAM2416EDK # dnw
Now, Waiting for DNW to transmit data
SAM2416EDK # resetOK
U-Boot 1.3.4 (Jun 30 2011 - 09:01:15) for SMDK2416
CPU: S3C2416@400MHz
Fclk = 800MHz, Hclk = 133MHz, Pclk = 66MHz
Board: SMDK2416 Mobile DDR
DRAM: 64 MB
Flash: 1 MB
NAND: 128 MB
*** Warning - bad CRC or NAND, using default environment
In: serial
Out: serial
Err: serial
Hit any key to stop autoboot: 0
NAND read: device 0 offset 0x40000, size 0x1c0000
1835008 bytes read: OK
Boot with zImage
Starting kernel ...
Uncompressing Linux.............................................................
................................ done, booting the kernel.
解决方法：修改flash分区信息
——————————————————————————————————————
先不纠结了，直接跳吧。往后也许会再遇到这个问题，或者辅助问题，或者明师益友
——————————————————————————————————————
再坚持了一把，终于内核移植成功。版本匹配问题，smdk最小板功能，重新解压再试一遍，这些很基本的方法在穷途末路时有时会有柳暗花明的效果。哈哈！
但之前我出错的根本原因我还是不知道，连自己怎么成功的都不知道，真惨。反思，反思，一定要找到。。。